USER MANUAL
Neon LED Configuration
Neon LED C
onfigur
ation
Toll Free: 866.592.3873
Email: [email protected]
www.SolidApollo.com
Installation
This section will show you how to cut the Neon LED, add a power adapter, install a joiner, and add an endcap to complete the configuration
for a fully waterproof seal. This manual also covers how to mount, install and use the mounting brackets.
All Neon LED can only be pow-
ered in one direction.
When cutting Neon, try to keep track of which end is cut. Please note, for outdoor or high humidity applications,
we recommend using waterproofing glue for all connections (as noted in instructions), and we recommend at least 24 hours of drying time
before installing or using the Neon.
Cutting the Neon:
Warning: Neon LED must be unplugged when any modifications are performed. 120V AC
Current is Dangerous and may cause electrical shock, injury and in some cases death.
Tools Required:
Sharp Metal Scissors or Shears (for cutting Neon at cut points)
Paper Towels (for excess glue)
Tong or Tweezer (for prong removal during testing)
Find the cut point on the Neon LED. Imagine a line passing from one side of the Neon LED to the other with the center being the
cut point symbol. Take either scissors or shears and line it up perpendicularly to the cut point and cut through the Neon LED.
Each Neon LED has cut points every 18” inches. Refer to the diagrams below for the cut point symbol found on the Neon LED.
Cut on line
Warning: Any tool with a blade is dangerous, and caution is advised when handling any blade. Please make sure
hands and fingers are kept at least several inches away from any blade and are not placed in the direction of the blade.
1
...continued on next page
Page 2
Neon LED Cut Point:
Neon LED (2-Prong)
CUT POINT
CUT POINT
