Solectek SkyMate, Руководство оператора

Страница: 43 / 124

SkyWay Series Multi-Point Operator’s Guide
29
Route Expire Age. 10 - 300 seconds . If the route has not been refreshed or
changed during this period of time (seconds), the route expires. When the route
expires the metric is changed to infinity(16).
Route Holddown Age. 0 - 300 seconds . The period of time in seconds after a
route has expired before it is deleted.
RIP Port Configuration
RIP port configuration defines the RIP running policy on different physical ports.
Port IP Address. The IP address of the physical port on which a RIP running
policy is defined. It selects automatically by RIP and user can not change it.
Auth Type.
No Authentication, Simple Password or MD5 . The type of
authorization used on this interface. RIP Authorization only supported by RIP II.
If it's enabled, the RIP route will only accept routes with the same authorization
key as that of itself.
Note: The MD5 is not fully supported on current software version.
Authorization Key. Max length is 16, letter or digit . The value to be used as the
Authorization Key whenever the corresponding Authorization type has a value
other than No Authentication. A modification of the corresponding Authorization
type does not modify the authorization key value. The Authorization key.
Send Mode.
doNotSend, RIP1 (implies sending IP updates compliant with RFC
1058), V1-Compatible (implies broadcasting RIP2 updates using RFC 1058 route
subsumption rules) or RIP2 (Implies multicasting RIP2 updates). Indicates what
the router sends on this interface. The border RIP1 router will not send out internal
subnets information.
Receive Mode . RIP1, RIP2, RIP1orRIP2 or doNot Receive . This indicates
which versions of RIP updates are to be accepted. Note that RIP2 and RIP1orRIP2
implies reception of multicast packets.
Metric. The default RIP route cost of the physical connected network.
Configuring for RIP
Ensure the IP routing is enabled before configure the RIP. If not, see “Configuring
for Routing Only” on page 20.
After IP routing is enabled, a default RIP port configuration record will be added
for each physical port.