14
3
CONSOLE
MAST
HARDWARE
STEP 3
1.
Install the Console Mast Cover (
31
) onto the Console Mast (
2
).
Make sure the plastic cover is in the correct orientation
2.
Feed the twist tie that is attached to the Computer Cable (
44
)
and Hand pulse Cable (
45
) through the bottom of the Console
Mast Tube (
2
) and out through the opening at the top.
3.
Install the Console Mast Tube (
2
) into the receiving tube (pull
gently upwards on the cable ends
to prevent pinching the
cables because damage to the electronics could occur) of the
Main Frame (
1
) with six Hex Head Bolts (
68
), four Flat
Washers (
76
) on the sides of the tube and two Curved
Washers (
83
) on the front of the tube by using the 12/14mm
Wrench (
112
).
4.
Remove the white Styrofoam pad (factory installed to prevent
bolts from being accidentally dropped into the Bike).
5.
Remove the plastic tie from the center of the handlebar (
3
).
Install the Mast Handle bar Assembly (
3
) onto the Console
Mast (
2
) with two Hex Head Bolts (
68
), two Flat Washers (
76
)
and two Split Washers (
82
) using the 12/14mm Wrench (
112
).
#68
. 5/16” x 5/8”
Hex Head Bolt (8 pcs)
#76
. 5/16” x 18mm x 1.5T
Flat Washer (6 pcs)
#82
. 5/16” x 1.5T
Split Washer (2 pcs
)
#83
. 5/16” x 19mm x 1.5T
Curved Washer (2 pcs)
Содержание B94
Страница 10: ...9 4ASSEMBLY STEP 4 ...
Страница 29: ...28 UPRIGHT EXPLODED VIEW DIAGRAM ...
Страница 32: ...31 RECUMBENT EXPLODED VIEW DIAGRAM ...
