Sole Fitness B94, Руководство пользователя

Страница: 9 / 38

8
#51 . 5/16” x 5/8”
Hex Head Bolt (2 pcs)
#72 . 5/16” x 18mm x 1.5T
Flat Washer (2 pcs)
#103 . 5/16” x 1.5T
Split Washer (2 pcs)
4
#58
. M5 x 12mm Phillips
Head Screw (6 pcs)
3
HANDLE BAR
HARDWARE STEP 3
1. Remove the plastic tie from the center of the handlebar (
3
).
Insert the two hand pulse cables ( 26 ) through the opening of
the handlebar mounting bracket on the front side of the
console mast tube (
2 ). Pull the cables through the opening of
the console mounting bracket at the rear of the console mast
tube.
2. Attach the Handle Bar ( 3 ) to the Front Console Mast ( 2 ) with
the two Hex Head bolts ( 51 ), two Flat Washers ( 72 ) and two
Split Washers ( 103 ). Tighten using the 12/14mm Wrench
( 100 ). Be careful not to pinch the cables when fastening.
PLASTIC PARTS
HARDWARE STEP 4
1. Insert the Computer Cable ( 29 ) and two Hand pulse cables
( 26 ) into the connectors in the back of the Console ( 34 ).
2. Attach the Console ( 34 ) onto the Console Mast ( 2 ) with four
Phillips Head Screws (
58
). Be careful not to pinch the cables
when fastening.
3. Attach the Front Stabilizer Cover ( 40 ) to the Main Frame ( 1 )
with two Phillips Head Screws (
58
). Tighten with the Phillips
Head Screw Driver ( 93 ).
4. Install the Pedals ( 45 L, 46 R) onto the Cranks by using the
13/15mm Wrench ( 92 ). Remember that the left pedal has a
reverse thread and will be screwed into the crank in the
opposite rotation from normal threads. There is an L stamped
into the end of the threaded post of the left pedal and an R on
the end of the right post. Make sure to tighten the pedals as
much as you possibly can. It may be necessary to re-tighten the
pedals if you feel a thumping while pedaling the bike. A clicking
noise or thumping feeling is usually caused by loose pedals.
5. Install the Seat mount slide ( 7 ) onto the track on top of the seat
tube with the seat post facing forward. Place the nut plate ( 8 )
onto the seat slide behind the seat post. Place the flat washer
(
71
) onto the fore/aft adjustment knob (
86
) and thread it into the
nut plate from underneath the seat tube track. Attach the seat
(
19 ) to the seat post using the 12/14mm Wrench ( 100 ).