Customer Service 1-888-707-1880 Dyaco Canada Inc. 2014
email: [email protected]
26
GENERAL
MAINTENANCE
1. Wipe down all areas in the sweat path with a damp cloth after each workout.
2. If a squeak, thump, clicking or rough feeling develops the main cause is most
likely one of two reasons:
I. The hardware was not sufficiently tightened during assembly. All bolts that were
installed during assembly need to be tightened as much as possible. It may be
necessary to use a larger wrench than the one provided if you cannot tighten the
bolts sufficiently. I cannot stress this point enough; 90% of calls to the service
department for noise issues can be traced to loose hardware or the rear rails
being dirty.
II. Dirt build-up on the rear rails and polyurethane wheels are also a source of
noise.
Noise from build-up on the rails can cause a thumping sound that you
would swear is coming from inside the main body of the machine because noise
travels, and is amplified in the tubing of the frame. Clean the rails and wheels
with a lint free cloth and rubbing alcohol. Stubborn build-up can be removed with
your thumbnail or a non-metallic scraper, like the back edge of a plastic knife.
After cleaning, apply a small amount of lubricant on the rails with your fingers or
a lint free cloth. You only need a thin coat of lubrication, wipe off any excess.
3. If squeaks or other noises persist, check that the unit is properly leveled before
calling the service department.
MAINTENANCE MENU IN CONSOLE SOFTWARE
1. Press and hold the
Start
,
Stop
and
Enter
key at the same time, until the display
shows “Maintenance Menu”. Press the
Enter
key.
2. You can now scroll through the menu using the
Resistance
Up/Down keys. Use the
Stop
key to return to previous menu selection. The menu selections are:
A. Key Test
B. Display Test
C. Functions
I.
Display Mode
- Turn on to have the console power down automatically after 30
minutes of inactivity
II.
Pause Mode
- Turned on to allow 5 minutes of pause, turn off to have console
pause in definitely
III.
ODO Reset
- Resets the Odometer reading to zero
IV.
Units
- Choose from English(Imperial) or Metric display readings
V.
Brake Test
- For testing the Brake function
D. Security
E. Factory Settings
F.
Exit
Incline Calibration:
If there is a problem with the incline, try running the calibration.
Press the
Incline
key and the
Start
key at the same time. Hold them down for 5 seconds
and the Incline calibration will start and run automatically. If the problem persists contact
service department.
