Sole Diesel 68 GTC, Руководство оператора

Страница: 53 / 82

Technical specifications
Solé, S.A. C-243 b, km 2 · 08760 Martorell (Barcelona) ·Tel. +34 93 775 14 00 · www.solediesel.com · info@solediesel.com 50
Operator’s Manual Marine generator sets
Increase speed by 15%. 5.9
Apply a 12V voltage for an instant across the electronic
regulator terminals using a battery with a 30 Ohm
resistance in series and remember to respect the polarities.
5.9
After the genset is excited it deactivates Check the wiring against the diagrams in appendix. 5.9
NO LOAD
VOLTAGE TOO
LOW
ALTERNATOR (AC)
Calibrate the voltage. 5.9
Check the rpm's. 5.9
Check the windings. 5.9
NO LOAD
VOLTAGE TOO
HIGH
ALTERNATOR (AC)
Calibrate the voltage. 5.9
Change the regulator. 5.9
UNDER LOAD
VOLTAGE
BELOW
NOMINAL
ALTERNATOR (AC)
Calibrate the voltage. 5.9
Current too high, cosφ very low, speed below 4% of nominal. 5.9
Change the regulator. 5.9
Check the diodes, unhooking the cables. 5.9
UNDER LOAD
VOLTAGE
ABOVE
NOMINAL
ALTERNATOR (AC)
Calibrate the voltage. 5.9
Change the regulator. 5.9
UNSTABLE
VOLTAGE
ALTERNATOR (AC)
Check for uniform rotation. 5.9
Control regulator stability by adjusting potentiometer. 5.9
BLACK SMOKE
FUEL SYSTEM
Fuel filter clogged Change fuel filter. 6.5
Fuel injectors dirty or faulty Clean, test and/or replace the inoperative fuel injector. 6.5
Injection pump incorrectly set Contact with our dealer -
INLET AND EXHAUST
SYSTEM
Air filter clogged Replace air filter element. 6.7
LOAD GENSET Propeller to large (not enough rpm)
The power curve of the genset is not adequate. Carry out a
propulsive power study.
-
BLUE SMOKE
GENERAL Valve clearance incorrect Adjust the valves. 6.3
LUBRICATION SYSTEM Oil level too high Restore the oil to normal operating level. 6.4