16 • Control Keypad
________________________________________________________________________________________________
Potentiometer
Range
Description
Ramp Down
0.5-10 sec.
Used to control deceleration of high friction loads. When Ramp-Down
potentiometer is set, upon stop signal the starter output voltage is
gradually ramped down.
When "Ramp-down Time" is set to minimum, the motor will stop
immediately.
7.2
Indication LEDs and RESET button
Green
On
Will lit when Control Supply voltage is connected to the starter.
Yellow
Ramp
Up/Down
Will lit during soft start and soft stop process, indicating that motor supply voltage
is ramping up or down.
Green
Run
Will lit after completion of starting process, indicating that motor is receiving full
voltage.
Red
Overload
Will lit upon operation of the built-in overload protection.
Red
Fault
Will lit upon operation of the under voltage and phase loss protections and will
flash upon operation of the heatsink over temperature protection.
Reset
Button
To reset the starter, after the fault has been removed.
U%
0.5
100%
10 sec
