5. Installation
5.1 Check for Physical Damage
5.2 Packing List
Make sure the inverter is intact during transportation. If there is any visible
damage, such as cracks, please contact your dealer immediately.
Open the package and take out the product, please check the accessories first.
The packing list shown as below.
Installation
Installation
Object
A
B
C
D
E
F
Inverter
Bracket
Expansion tubes & Expansion screws
Battery connectors (1*positive, 1*negative)
Description
Object
G
H
I
J
K
L
Quick installation guide
Description
Installation Precaution
X1-Retro Fit Series inverter is designed for outdoor installation (IP 65).
Make sure the installation site meets the following conditions:
Not in direct sunlight.
Not in areas where highly flammable materials are stored.
Not in potential explosive areas.
Not in the cool air directly.
Not near the television antenna or antenna cable.
Not higher than altitude of about 2000m above sea level.
Not in environment of precipitation or humidity (
＞
95%).
Under good ventilation condition.
The ambient temperature in the range of -20
℃
to +60
℃
.
The slope of the wall should be within
±
5
°
.
The wall hanging the inverter should meet conditions below:
1.solid brick/concrete, or strength equivalent mounting surface;
2.Inverter must be supported or strengthened if the wall’s strength isn’t
enough(such as wooden wall, the wall covered by thick layer of decoration)
Please AVOIDE direct sunlight, rain exposure, snow laying up during installation
and operation.
A
5.3 Mounting
B
C
D
E
K
L
18
19
M
M
Warranty card
4 6AWG AC terminals and 4 10AWG AC terminals for Version I
8 10AWG AC terminals for Version E and Version C
Version I
Version E&C
N
N
O
O
Pocket wifi/LAN/GPRS (optional)
F
I
J
H
G
Ring terminal(1*for external enclosure grounding)
Set screw( for mounting)
Grounding nut
gasket( for using thin cable to connect on the AC port)
Ring terminal(2*for internal enclosure grounding)
User manual
P
12 pin positive terminal
cable connector*2
P
