Mechanical Installation
Mechanical Installation
29
28
b) Use the bracket as the template to mark the screw hole location on the
wall;
c) Unscrew the two M4*8 screws to disassemble the bracket. Drill holes
with power drill, and make sure the holes are deep enough (2.36 in./60 mm) to
support the inverter.
The figure below is only used for showing the depth and location of
holes. Make sure the holes are in the center of each stud and keep at
least 1.5in. /38mm away from the edge of concrete bricks or studs
before marking holes.
NOTE!
Round holes
Depth:
2.36 in./60 mm
Φ
10 drill
c) Insert the expansion tube into the hole and use rubber hammer to knock
the expansion tube into the wall; (It can be ignored in case of wooden wall.)
e) Align the bracket over the holes and re-fix the bracket on the BMS with
screws. And set the tapping screw through the washer and secure the bracket with
M6 tapping screws. Please hold the bracket firmly to the wall surface before fixing
it.
Torque wrench
92 lbf.in/
10.4 N·m
