Solas THIRTY8 BI-38N-C, Руководство по установке и эксплуатации

Страница: 33 / 51

32
LIGHTING & OPERATION
WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing
property damage, personal injury or loss of life.
When lighting this appliance, follow these instructions exactly.
A. This appliance is equipped with an ignition device that automatically lights the pilot. Do not try to light the pilot by
hand.
B. BEFORE OPERATING THE BURNER SYSTEM, smell around the appliance area for gas. Be sure to smell next to the floor
because some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light the appliance.
• Do not touch any electric switch; do not use any telephone in your building.
• Immediately call your gas supplier from a neighbor’s telephone. Follow the gas supplier’s instructions
• If you cannot reach your gas supplier, call the fire department.
C. Use only your hand to operate the gas controls. Never use tools. If a knob will not push in or turn by hand, don’t try to
re-pair it, call a qualified service technician. Force or attempted repair may result in a fire or explosion.
D. Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect
the appliance and to replace any part of the control system which has been under water.
OPERATING INSTRUCTIONS
1.
STOP! Read the safety information above on this label.
2. This appliance is equipped with an ignition device that automatically lights the pilot. Do not try to light the pilot by
hand.
3. Using the Remote Handset, or the optional Wall Switch, push the “OFF” button until you hear an audible signal to
insure the appliance is off.
4. Wait five (5) minutes to clear out any gas. Then smell for gas including near the floor. If you smell gas, STOP! Follow
“B” in the safety information above. If you don’t smell gas, proceed to step 5.
5. Using either the Remote Handset, or the optional Wall Switch, simultaneously press the “ON” and
“High Flame” buttons. An audible signal confirms the start sequence has begun.
6. Continuing beeps confirm the ignition is in process. Once lighting the pilot flame should appear as shown in Fig.2.
Once the pilot is confirmed, the main burner ignites on high.
NOTE: If the pilot does not stay lit after several tries, proceed to step 9.
7.
Use the flame height adjustment buttons on either the Remote Handset or the optional Wall Switch to adjust the
flame. Press the button twice to decrease the flame height to its lowest setting, press the button twice to
increase flame height to the highest setting. Pressing the or button once will modulate the flame to intermediate
settings. The Remote Handset can also be used to control the appliance thermostatically.
8. Press and hold the button on the Remote Handset or optional Wall Switch to set the appliance to Pilot flame only.
9.
If the appliance will not operate, follow the instructions “TO TURN OFF GAS TO THE APPLIANCE” and call your gas
service technician or gas supplier.
TO TURN OFF GAS TO THE APPLIANCE
1.
To turn off gas to the appliance,
push and release the “OFF”
button on either the Remote
Handset or the optional Wall
Switch. An audible signal will
confirm.
10.
TO TURN OFF THE GAS SUPPLY
TO THE APPLIANCE, close the
shut-off valve on the gas supply
line to the appliance.