Solas FORTY6 VF, Руководство по установке и эксплуатации

Страница: 18 / 35

17
ASSEMBLY & INSTALLATION
INSTALLING OUTER PAN INSTALLING OUTER PAN INSTALLING OUTER PAN INSTALLING OUTER PANELS ELS ELS ELS
1.
The four outer decorative panels are
secured to the fire-place with Philips head
screws. The top and bottom panels are
secured to the fireplace mounting plate
with sheet metal screws. All other screws
are Philips head machine screws.
2.
Install the top panel first. Align the three
holes along the rear edge of the panel with
pilot holes along the top edge of the
fireplace mounting plate.
3.
Insert and tighten the three sheet metal
screws. A magnetic nut driver is helpful.
4.
Install the left side panel next. Align the
three holes along the rear edge of the panel
with the PEM nuts along the edge of the
fireplace mounting plate. Insert the three
Philips head screws but do not fully
tighten.
5.
Locate the fastener hole at the top front
edge of the left side panel and align with
the PEM nut in the front of the top panel.
Insert the Philips head screw.
6.
Make sure the edges of the panel are aligned with the edges of the top panel and mounting plate
and tighten all four Philips head screws.
7.
Position the right side panel so it aligns with the three PEM nuts on the mounting plate and the
front PEM nut on the top panel. Align the rear and top panel edges with the adjoining parts and
insert and tighten the four Philips head screws.
8.
Install the bottom panel next. Guide the rear flange on the panel upward until the mounting
holes in the flange line up with the pilot holes in the mounting plate.
9.
Attach the panel to the mounting plate using sheet metal screws along the back edge of the
panel. Note: It may make installation of the sheet metal screws easier if you remove the two
lower surround mounting brackets from the front of the fireplace, replace brackets before
operating fireplace. A magnetic nut-driver will also be helpful.
10.
Attach the bottom panel to the side panels by aligning the fastener holes in the bottom panel
with the PEM nuts in the front corners of the bottom flanges on the side panels. Insert and
tighten the two Philips head screws.
Only trim kit(s) supplied by the manufacturer shall be used in the installation of this appliance.