scReW fiXtuRes
Fastening on the fastening holes with screws.
clAMPing sYsteM
Fix in place with suitable module clips
2
The bracket must not distort the solar
module and the clips must not come into
contact with the front pane. Please pay
attention to the clip manufacturer’s
specifi cations. The clip surfaces must be
suffi ciently sized (areas of 500 mm² per
fastening point are required).
nOte
It is not permitted to use SOLARWATT solar modules as overhead glazing. For roof instal-
lation, these solar modules may only be installed over a fi re-resistant roof covering.
areas approved for fastening
Fastening on long sides
The maximum pressure load to the solar mod-
ule for the installation method 2,400 N/m².
Fastening on short sides
The maximum pressure load to the solar mod-
ule for the installation method is 2,400 N/m².
Fastening on long sides
The maximum pressure load to the solar module for
the installation method is 3,500 N/m².
Fastening on short sides
In addition, this fastening mode requires a central,
round or linear support on the lower frame side (cen-
tral support). The maximum pressure load to the solar
module for the installation method is 2,400 N/m².
Vertical installation
Horizontal installation
100 mm
100 mm
20
0
m
m
20
0
m
m
10
0
m
m
10
0
m
m
10
0
m
m
10
0
m
m
200 mm
200 mm
13
STATUS: 06/2016 | INSTALLATION INSTRUCTIONS Rev. 007 | Subject to change | © 2016 SOLARWATT GmbH
