Solarbayer BioX 15, Руководство по эксплуатации

Страница: 40 / 80

Fuels
40
© Solarbayer GmbH [210205]
6 FUELS
The Solarbayer BioX is suitable for burning logs to
operate central heating systems for closed hot
water installations. Smaller split logs enable higher
boiler performance than whole ones. We
recommend triangular firewood with side lengths of
50cm and edge lengths of 8cm . To course or to
long firewood may lead to reduced performance
and hollow fire. The heat value of the wood is
primarily dependent on its dampness content. The
heat value decreases with increased dampness.
The combustion of wood with high dampness
content also causes a decrease in the degree of
efficiency of the boiler.
Wood should therefore be stored for at least two
years in a dry, ventilated place. Oak needs to be
stored for about a year longer. Dry bark displays a
heat value similar to wood but there is more likely
to be increased formation of ash.
The burning of unsuitable fuels could lead to
uncontrolled combustion. The guarantee expires!
Breakdowns and consequential damage are
probable.
Possible consequential damage:

Damage to the thermodynamic combustion
chamber, the lambda sensor, the exhaust gas
sensor due to aggressive residues in the
boiler.

Soot formation or corrosion in the filling area
due to condensation resulting from the use of
excessively wet fuel.

The escape of exhaust gas from the airflow
apertures through uncontrolled combustion
(deflagrations).
Combustion time at nominal load up to
Combustion time in hours
Type BioX
15
BioX
20
BioX
25
BioX
35
BioX
45
Softwood 5 4 6 5 3,5
Hardwood 6 5 7 6 4,5
6.1 Suitable fuels
The firewood must be air-dried, that is, dried at
least one year with water content below 20%,
preferable half-meter logs with an average
diameter of 10cm. Are the cleavage planes of the
log much longer, according to the log should be
thinner, in extreme cases 20 to 5cm.