August 2020
|
Solar Stik
®
, Inc.
76
|
24VDC PRO-Verter 7000-120 AGS Operator Manual
PRO-Verter / Inverter Reset
To perform an inverter reset (also known as a “hard reset”):
1. Ensure all AC power (i.e., shore power or generator) is removed from the PRO-Verter input.
2. Remove the PRO-Verter Faceplate. The control board on which the Power ON/OFF push button
and LED are mounted is in the center of the PRO-Verter.
3. Press and hold the Power ON/OFF push button for approximately ten (10) seconds until the
Charging/Inverting Status LED comes on and flashes rapidly.
4. When the rapid flashing has begun, release the Power ON/OFF push button. The Status LED will
go off after the button is released.
5. After the inverter reset is completed, press the Power ON/OFF button to turn the inverter ON.
Some older inverter models do not allow an inverter reset. If the inverter reset fails, you will need
to perform a power reset using the procedure below. In either case, if an internal fault does not
clear, call Solar Stik Technical Support at 800-793-4364 Ext 102.
Note:
The Power ON/OFF push
button is a small momentary-type
switch that operates by lightly
pressing and releasing. Be careful
not to apply too much force when
pushing or the switch might break.
LED
Power
ON/OFF
