Softing FG-200 HSE/FF, Руководство пользователя

Страница: 37 / 82

Chapter 6 - Using the web interface
Version EN-112021-1.30.3
37
Enable HSE Alarms
The FG-200 is able to use the already configured alarm VCRs in the FF-H1 devices or can established new
ones. Or it will configure the FF-H1 devices accordingly. The behavior depends whether the Visitor Mode is
enabled or not.
Link Master Functionality
In case of visitor mode it can make sense to disable the Link Master functionality. If no Link Master is
available on a segment connected to an activated H1 Link of the FG-200, a timeout will occur after 6
minutes to indicate this. The FG-200 will not be visible in the HSE live list during this period. To avoid this
assure that a Link Master is present for all activated H1 Links or deactivate H1 Links of the FG-200.
Visitor Mode
When the FG-200 is in visitor mode it can be connected to a running FF-H1 network with the FF-Host
system without affecting the established communication.
Enable Modbus
This button enables or disables Modbus TCP.
Enable RTU
Modbus RTU runs over the same serial interface (RS232) which is necessary to establish an application with
HSE device redundancy. To use redundancy together with Modbus TCP the feature "Modbus RTU" has to
be disabled.
Note
If you are using Modbus TCP, activate the option Enable Modbus only.
If you are using Modbus RTU, activate both options Enable Modbus and Enable RTU .
The button [Change Settings] allows you to update the settings. To see the updated values click General
Settings
again.