socomec ATyS t M, Инструкция по эксплуатации, Страница: 28 / 32

28
EN
13.4. Programming
I* !* %" / ' " **%$ ; %/ .% !. .%"!$
.%"! ! * # .! % ) # +!*" " ..%)" .%*$
M3 '**' %* ) .%"! !..* % F!..* M3 *G$
% ". ( % %. 0240 %)$
The commissioning must always result in having at least 1 LED source available lit..
Therefore, the voltage and frequency must be within the defined thresholds.
Any action on the potentiometers changes the settings, even if the cover is closed.
13.4.1. K7
.%"! %"( %! %'! !%** %* )%*'  %* +!$
%( * % %) %.:
$ 8! ". @ .%% @$
$ ** *" #*/'$
$ ** *" %( % #*/' %$
$ 8! ". @ .%% : .%"! " % %/$
M3 '**' " %.% %* ) .%"! !..* )*#*$
% ". ( % %. !%2!* %)$
%%' ! * !* )' * M3 %! )*#* %$
F%( )%*' " +! ! # "" %*"G$
% % .%% ** ' '( ) %) *%"$
FT
Source LED ON LED OFF LED blinking
Source 1
available Source 1
missing or
out of
range - a timer is
counting
down
- test mode
Source 2
available Source 2
missing or
out of
range - a timer is
counting
down
Source availability LED
E: No stop in O position
F: 2s stop in O position
Stop in 0 position: E-F
Thresholds: C-D
A: Ready
B: Auto Conf
(Auto-configuration)
Setting mode: A-B
G: With priority
H: Without priority
Type of application: G-H
HYST: 20 % of
6
U/F settings
Dip switch settings Led info
A
Loss of priority source timer
FT: 0-30 sec.
U/F
[HYST]
[HYST]
RT: 0-30 min.
U/F
Timer settings
B C
Fault reset
LED ON LED OFF LED blinking
Fault Product OK Wait
Auto mode Manual
mode
Manual
retransfer
Fault and state of the product Leds
RT