CHAPTER 2: SETUP
|
19
CSA connects either automatically or with manual initiation.
Depending on how your configured the CSA, it may automatically connect
with the remote device, or you may need to manually initiate a connection.
In the previous scenarios, the following should happen:
SCENARIO 1: Set up a CSA pair for cable replacement.
After you attach the CSA to each device (with each powered on), they
should automatically try to connect.
Example: After you attach the initiator CSA to the laptop and the acceptor
CSA to the printer, the two CSA’s will automatically try to connect.
SCENARIO 2: Set up one CSA as passive serial
Bluetooth
receiver.
After you attach the CSA, your device will be discoverable and ready to
accept a
Bluetooth
connection. Perform a device discovery from the
initiator device, then commence the connection.
Example: The industrial equipment with the CSA will be discoverable and
ready to accept a Bluetooth connection. Perform a device discovery from
the Bluetooth enabled Pocket PC, then start the connection.
Important!
Make sure you manually configure your baud rate and other settings in any
third-party applications used with the CSA. Auto-detect and Plug and Play
functions are not reliable with Bluetooth, and the CSA may not work
properly unless you manually enter the correct settings.
