Socionext Inc.
SynQuacer E-Series Assembly Instructions
http: //www.socionext.com/
11/32
Copyright 2018
4-3. How to open and close the case
When doing the assembly work, first open the case and place it on its side.
How to open the case
1. Remove the two screws at right, as seen
from the rear.
2. Place your hand on the side cover (the right side of
the case) and pull it towards you.
The side cover may feel a little stiff when pulled. Do
not use excessive force when pulling, in order to
avoid injury.
3. Remove the side cover you pulled out towards the
outside.
4. Place the case on its side.
How to close the case
1. Fit the cover that you removed onto the chassis by
sliding it a bit towards the rear, and install the cover
by sliding it towards the front of the case. When
doing this, fit the cover over the tabs at the center
and at the front of the case by pulling carefully,
installing the cover snugly onto the front side.
The cover may feel a little stiff when installing. Do not use excessive force when pulling, in order
to avoid injury.
2. Use the screws that you removed when opening the case to fasten the side cover on.
CAUTION
There are sharp edges on the rear side of the side cover and inside the case.
Also note that you will need to apply some force to open and close the case.
Use caution not to injure yourself by getting your hands pinched or cut by the
case or cover. Use gloves if necessary.
1. Remove
the screws
3. Remove towards
the outside
2. Pull towards you
Pull the cover towards the
front while pushing down
