SNOWJOE Sunjoe SPX7001E, Руководство оператора

Страница: 14 / 20

14
4. Remove any debris or dust from the dust bin. Rinse the
dust bin with warm water if needed. Replace the dust tank
cap with filter and lock the dust bin securely in the unit
before using.
Tra Storage
m
CAUTION!
Always store your pressure wet/
dry vacuum in a location where the temperature will not fall
below 32ºF (0ºC). The pump in this machine is susceptible to
permanent damage if it freezes. FREEZE DAMAGE IS NOT
COVERED BY THE WARRANTY.
• Use the top handle to lift the machine up. If needed, push
the telescopic handle lock to use the telescopic handle on
the back (Fig. 21).
• Store the pressure washer + wet/dry vacuum indoors
in a dry, covered area where it is not subject to adverse
weather conditions.
• It is important to store this product in a frost-free area.
• Always empty water from the dust tank, all hoses, the
pump, and the foamer cannon (if using) before storing.
• Use the accessory holders and the trigger gun holder on
the back of the machine to store the accessories and the
trigger gun, as shown (Fig. 22).
m
CAUTION!
The use of a pump protector is
recommended to prevent cold weather damage during storage
over the winter months.
Winte long-term storage
If you must store your pressure wet/dry vacuum in a
location where the temperature falls below 32ºF (0ºC), you can
minimize the chance of damage to your machine by utilizing
the following procedure:
• Disconnect all water connections.
• Turn on the machine as pressure washer for a few
seconds until the remaining water in the pump exits. Turn
off immediately.
• Do not allow the high-pressure hose to become kinked.
• Store the machine and accessories in a room that does
not reach freezing temperatures.
• Do not store near a furnace or other sources of heat that
may dry out the pump seals.
• Operate the pressure washer with non-corrosive/non-toxic
anti-freeze, a pump saver, or a pump protector before
storing for the winter.
m
WARNING!
Before reusing, completely flush the unit
out with clear water. Anti-freeze products can damage
paintwork, so you must ensure there is no anti-freeze left in the
system before using it again.
Fig. 20
Dust bin
Dust tank cap
with filter
Fig. 21 Telescopic
handle lock
Fig. 22
Accessory holder
Trigger gun
holder