SNOWJOE Sunjoe SPX7001E, Руководство оператора

Страница: 12 / 20

12
1. Remove the sprayer cap, and fill the foamer cannon bottle
with detergent designed specifically for use with pressure
washers (Fig. 15).
2. Recap the foamer cannon bottle, and attach it to the
trigger gun by inserting the tip of the locking collar into the
gun and twist clockwise to lock into place (Fig. 16).
3. The foamer cannon is equipped with a foam-volume
adjustable knob. Follow the instructions as shown to use
the foam-volume adjustable knob (Fig. 17).
4. Apply detergent from the bottom to the top of the dry
surface to be cleaned. Applying detergent in this manner
will dissolve dirt most effectively.
NOTE: Wetting the surface first is not recommended as it
dilutes the detergent and reduces its cleaning ability.
m
CAUTION!
Always test the detergent in an
inconspicuous area before use.
5. Allow the detergent to remain on the surface for a short
time before rinsing with the pressure washer. Do not allow
the detergent to dry on the surface.
m
CAUTION!
Damage may occur to painted surfaces if
the detergent is allowed to dry on the surface. Wash and rinse
a small section at a time. Avoid working on hot surfaces or in
direct sunlight.
6. Rinse with clean water. When working on a vertical
surface, wash from the bottom up, then rinse from the top
down to avoid streaking. Hold the nozzle 6-8 inches away
from the work surface at a 45° angle.
m
IMPORTANT!
NEVER USE:
• Bleach, chlorine products, and other corrosive chemicals
• Liquids containing solvents (e.g. paint thinners, gasoline,
oils)
• Tri-sodium phosphate products
• Ammonia products
• Acid-based products
These chemicals will harm the unit and will damage the
cleaning surface.
Shutting down
1. Turn the switch to the OFF (0) position and unplug the
power cord from the outlet.
2. Turn off the water source.
3. Hold the trigger to release water pressure.
4. Disconnect the garden hose from the water inlet on
the unit.
5. Disconnect the high-pressure hose connection on the
trigger gun handle.
6. Release the trigger and engage the gun safety lock.
m
WARNING!
Turn off the water supply and squeeze the
trigger to depressurize the unit. Failure to do so could result in
personal injury due to discharge of high-pressure water.
Taking a break
If you are taking a break of five minutes or more between
cleaning tasks:
1. Engage the gun safety lock (Fig. 12).
2. Turn the switch to the OFF (0) position.
3. Unplug the power cord from the outlet.
Fig. 15
Foamer
cannon bottle
Pressure washer
detergent
Sprayer cap
Fig. 16
Foamer cannon
Trigger gun
Fig. 17
Foamer cannon
Foam-volume
adjustable knob