SNOWJOE iON24SB-CT-RM, Руководство оператора

Страница: 20 / 28

19
4. Disassemble the housing by removing the cotter pin from
the chute control head and 6 housing bolts (3 on each
side) then remove the chute crank (Fig. 33).
5. Separate the thrower assembly from the drive unit
(Fig. 34).
6. Unscrew pulley bolt, washer, 3 screws and pulley cover
then remove the pulley 1 and bushing from the thrower
assembly (Fig. 35).
7. Disassemble the auger and impeller by removing the nuts
and bolts from the side of the auger housing (Fig. 36).
8. Remove 2 set of shear bolts and nuts from the auger
(Fig. 37).
9. Remove the auger bearings on both ends then remove the
2 auger blades from the auger shaft (Fig. 38).
10. Install the replacement auger blades by following the
above steps in reverse order.
Fig. 33
Cotter pin
Chute crank
Housing
bolt
(THROWER ASSEMBLY) (DRIVE UNIT)
Fig. 34
Auger belt
(THROWER ASSEMBLY)
(DRIVE UNIT)
Fig. 35
(THROWER ASSEMBLY)
Pulley
1
Screw
Washer
Pulley
cover
Bushing
Bolt
Fig. 36
Nut + bolt
Impeller
Auger
Auger
housing
Fig. 37
Shear bolt
Nut
Auger
Fig. 38
Auger bearing
Auger shaft
Auger blade