SNOWJOE iON24SB-CT-RM, Руководство оператора

Страница: 11 / 28

10
Chute Clean-Out Tool
The chute clean-out tool is fastened to the top of the auger
housing with a mounting clip (Fig. 9).
Skid Shoes Adjustment
Position the skid shoes based on surface conditions. Adjust
upward for hard-packed snow. Adjust downward when
operating on gravel or crushed rock surfaces.
The snow blower skid shoes are adjusted at the factory for
shipping purposes. Adjust them downward, if desired, prior to
operating the snow blower.
m
WARNING!
It is not recommended that you operate
this snow blower on gravel as it can easily pick up and throw
loose gravel, causing personal injury or damage to the snow
thrower and surrounding property.
1. For close snow removal on a smooth surface, raise skid
shoes higher on the auger housing. Allow 1/8 in. (3 mm)
between scraper blade and hard, smooth surface(s).
2. Use a middle or lower position when the area to be
cleared is uneven, such as a gravel driveway. Allow
1-1/4 in. (30 mm) between scraper blade and uneven or
gravel surfaces.
NOTE: If you choose to operate the snow blower on a
gravel surface, keep the skid shoes in position for maximum
clearance between the ground and the shave plate.
To adjust the skid shoes:
3. Loosen the 4 hex nuts (2 on each side). Move skid shoes
to desired position (Fig. 10).
4. Make certain the entire bottom surface of skid shoe is
against the ground to avoid uneven wear on the skid
shoes.
5. Retighten hex nuts securely.
Battery Pack Operation
The equipment is powered by a lithium-ion batteries. The
battery packs are completely sealed and maintenance free.
Battery Charge Level Indicator
The battery packs are equipped with a push button for
checking the charge level. Simply press the push button to
read off the battery charge level from the LEDs of the battery
indicator:
• All 3 level monitoring LEDs are lit: Battery charge level
is high.
• 2 level monitoring LEDs are lit: Battery charge level is
decreasing. Stop work as soon as possible.
• 1 level monitoring LED is lit: Battery is flat. Stop work
IMMEDIATELY and charge the battery. Otherwise the
battery’s service life will be greatly shortened.
NOTE: If the charge level button does not appear to be
working, place the battery pack on the charger and charge as
needed.
NOTE:
Immediately after using the battery pack, the charge
level button may display a lower charge than it will if checked
a few minutes later. The battery cells “recover” some of their
charge after resting.
Charger Operation
m
WARNING!
Charge Charge only iONMAX 40V
lithium-ion battery packs in compatible iONMAX 40V System
chargers. Other types of batteries may cause personal injury
and damage.
To reduce the risk of electric shock, do not allow water to flow
into the charger's AC/DC plug.
Fig. 9
Chute clean-out tool
Fig. 10
Skid shoe
Hex nut
Charge level button
The battery is at 30% capacity
and requires charging
The battery is at 60% capacity
and requires charging soon
The battery is at full capacity
Light Indicators Lights