SnowEx V-Pro 32200, Руководство пользователя

Страница: 15 / 24

Lit. No. 74256, Rev. 02 15 February 15, 2020
OPERATING THE SPREADER – CAB CONTROL
Material
Width
Material
Flow
VIBRATE LIGHT STROBE PREWET
MIN MAX
ON/OFF
MIN MAX
BLAST
Material Width
Control Knob
(spinner speed)
Indicator Lights
(eight per knob)
Material Flow
Control Knob
(feed rate)
Status/Error Code
Display (red)
Accessory
Control Buttons
BLAST Button
(maximum application)
ON/OFF Button
& Emergency Stop
POWERING THE CONTROL
Power is not applied to the control until the vehicle
ignition is turned to ACC or ON. Once the control
has power it performs a light check and displays the
software version on the status display. The control
then checks for a connected spreader. If no spreader
is detected, the control does the following:
• nC (no connection) appears on the red status
display for fi ve seconds.
• A single beep will sound.
• Control enters standby mode with no lights
illuminated.
If any button is pressed on the control, it will wake and
check again for spreader connection. If no spreader is
detected, it will act as described above. If a spreader
is detected, it will transition to ready mode.
STARTING AND STOPPING SPREADER
To start the spreader , press the ON/OFF button. The
control backlights are illuminated when the vehicle
ignition is ON and the spreader is connected. When
the spreader is ON, the ON/OFF button and inner arc
around each control knob will also illuminate.
To stop the spreader , press the ON/OFF button
again.
The ON/OFF button also operates as an emergency
stop when required.
NOTE: The vehicle ignition must be ON to start
the spreader.
NOTE: If vehicle ignition is turned OFF while
spreader is running, the motors will stop.