SnowEx SP-2200, Руководство оператора

Страница: 28 / 36

Model # SP-2200
Operating the Spreader
(continued)
WARNING PROTECTION
t
If audible beeping occurs, read display to identify problem. If display reads OL (overload) or OH (overheat), shut
controller down and carefully clear jammed auger. If display reads E1 this means there is a dead short in system. Do not
use until problem is corrected. If display reads E0 this means that the motor is not getting any power. Check all
connections If display reads LB the vehicle battery is extremely low (possibly caused by a poor or corroded connection)
and could damage the system.
t
If there are any problems while operating the spreader, refer to Troubleshooting Guide.
AUTO-REVERSE AR FUNCTION
t
If your controller displays OL this could indicate a jammed auger.
t
To engage the Auto-Reverse AR function:
Step 1: Shut the Main Power Switch OFF for 3 seconds.
Step 2: Turn the Main Power Switch ON. When the machine starts back up the AR sequence will automatically start
and the auger will reverse for several rotations to clear the jam.
t
After a pause of several moments, the auger will automatically return to correct rotation.
t
If the jam is still not cleared, the controller will again display OL .
t
You may repeat Steps 1 & 2 for a second and third time.
t
If after the third try the controller displays OL — you must extract the material that is causing the problem.
t
Follow all warning directions when clearing jams.
/LW1R5HY
28
-XO\