SnowEx SP-2200, Руководство оператора

Страница: 30 / 36

Troubleshooting
Model # SP-2200
SPREADER
DOES NOT RUN
JAMMED MATERIAL
BAD MOTOR
CHECK WITH TEST KIT
BAD TRANSMISSION
CHECK WITH TEST KIT
CORROSION
BAD CONTROLLER
CHECK WITH TEST KIT
SPREADER UNPLUGGED
MOTOR POWER CORD
DISCONNECTED
INSIDE DRIVE ASSEMBLY
BREAK IN
WIRING HARNESS
CHECK WITH TEST KIT
CORROSION
LOOSE CONNECTION
LOAD TEST BATTERY
REPLACE
AFFECTED
COMPONENTS
BAD CONTROLLER
CHECK WITH TEST KIT
SWITCH OFF & ON
FOR AUTO-REVERSE
FUNCTION
CLEAR JAM
TEST 4 TO 20 AMP DRAW
NO LOAD GOOD
20+ AMP DRAW
NO LOAD BAD
TEST TURN SHAFT
BY HAND
SHOULD TURN FREELY
REPLACE ALL
CORRODED
CONNECTIONS
PLUG IN SPREADER
OPEN ACCESS COVER
AND PLUG TOGETHER
REPLACE HARNESS
REPLACE ALL CORRODED
CONNECTIONS
TIGHTEN OR REPLACE
REPLACE
DEFINITION:
AMP DRAW
TOO HIGH
DEFINITION:
OPEN CIRCUIT BETWEEN
MOTOR AND CONTROLLER
BAD ELECTRICAL
CONNECTION
LOW BATTERY
LESS THAN 12 VOLT
OUTPUT
DEAD SHORT
IN MOTOR CIRCUIT
CHECK HARNESS
FOR SPLICED IN
ACCESSORY
BAD CONTROLLER
CHECK WITH TEST KIT
CONTROLLER TURNS ON
BEEP SHUTS OFF
DISPLAYS ERROR CODE
ON/OFF SWITCH
LIGHTS NO DISPLAY
NOTHING HAPPENS
NO DISPLAY
ON/OFF SWITCH WILL
NOT LIGHT UP
OL CODE
EO CODE
LB CODE
E1 CODE
ALL OTHER
CODES
CHECK POWER SOURCE
TO CONTROLLER
BAD CONTROLLER
CHECK WITH TEST KIT
DON'T FORGET
USE DIELECTRIC
GREASE
/LW1R5HY
30
-XO\