SnowEx SP-2200, Руководство оператора

Страница: 27 / 36

Operating the Spreader
PREPARATION
CAUTION –
Sweep area clear of foreign objects or obstacles that could cause personal injury. Keep other persons, children, or
animals out of the area to be spread.
SPREADER LOADING
WARNING – Do not overload vehicle. Use chart below to calculate weight of material. Weights of material are an average for dry
materials.
Material Weight Per Cubic Ft.
Rock Salt 35-40 lbs.
Sand/Salt Mix 95-120 lbs.
t
Be sure to comply with manufacturer’s maximum gross vehicle weight ratings.
t
Warning
– Never leave materials in hopper for long periods of time as salt is hygroscopic and will attract atmospheric
moisture and harden up. When spreading sand mix, a 1:1 ratio for Sand/Salt mix is recommended to prevent the material
from freezing.
SPREADING TIPS
t
Never exceed 10 m.p.h. when spreading.
t
For a wider pass, increase spinner speed.
t
For a heavier pass, drive slower, or increase auger speed.
t
Never operate spreader near pedestrians.
t
Spread ice melters with the storm to prevent unmanageable levels of ice.
t
Calculate spread pattern when near vegetation.
2200 CONTROL OPERATION
t
The Dual Variable Speed Control has dual finger-tip dials for maximum performance, digital system status with warning
protection and built-in Vibrator Switch.
t
To start, press power switch on controller and spreader will accelerate to speed set on spinner and auger dials.
t
To stop, press power switch on controller to off position.
t
Speed of auger and spinner may be adjusted separately to get desired flow and spread distance from spreader.
t
The Vibrator Switch is needed for dense material or to increase the flow to the auger. This eliminates bridging of material
in hopper.
Model # SP-2200
/LW1R5HY
27
-XO\