Snorkel ML10I, Руководство оператора

Страница: 18 / 28

Chapter 5 – Operation
14 ML5I • ML10I • ML15I • ML20I • ML25I – 7030242
10. Engage the locking toggle on the fork retainer pin.
11. Rotate the carriage hold-down bar up and away from
the carriage.
Material lifts equipped with adjustable forks
1. Pull up on the snap pins.
2. Adjust the forks to the desired width.
3. Verify that the snap pins are properly inserted.
To install fork extensions
1. Slide the extension tube onto the fork.
2. Adjust the extension tubes to the desired position.
3. Insert the retaining pins through the extension tube
and the fork.
Material lifts equipped with a load platform
1. Place the load platform on the forks.
Positioning the Load
1. Determine the following before placing a load on the
material lift:
y
Weight of the load.
y
Location of the load center.
y
Distance between the load center and the side of the
load that will be closest to the carriage.
Note
Load center refers to the center of gravity of the load and
may not be its physical center. The heaviest side of an
uneven load should always be positioned closest to the
carriage on the material lift.
2. Refer to the chart below to determine if the material
lift can lift the desired weight.
Warning
Raising a load that exceeds the maximum load capac -
ity of the material lift creates a tip over hazard. Death
or serious injury could result from such accidents. Do
not exceed the load capacity values indicated on the
machine serial plate and in this Operator’s Manual.
3. Place the load on the load lifting attachment.
Warning
Raising a load that is not properly centered on the
material lift creates a tip over hazard. Death or serious
injury could result from such accidents. Properly
center the load before using the material lift to posi -
tion the material.
4. Position the load as close to the carriage as possible,
with the load center centered between the forks.
Warning
Raising a load that is not securely fastened to the load
lifting attachment creates a tip over hazard. Death
or serious injury could result from such accidents.
Securely fasten the load before using the material lift
to position the material.
5. Secure the load to the load lifting attachment.
Model
14″
36 cm
Load Center
24″
61 cm
42″
107 cm
ML5I 1000 lb
454 lg
750 lb
340 lg
350 lb
159 lg
ML10I
900 lb
408 lg
750 lb
340 lg
350 lb
159 lg
ML15I 800 lb
363 lg
700 lb
318 lg
325 lb
147 lg
ML20I 750 lb
340 lg
550 lb
249 lg
300 lb
136 lg
ML25I 600 lb
272 lg
400 lb
181 lg
200 lb
91 lg