Snorkel ML10I, Руководство оператора

Страница: 10 / 28

Chapter 3 – Safety
6 ML5I • ML10I • ML15I • ML20I • ML25I – 7030242
Always look in the direction of movement.
y
Position the material lift with care and at speeds com-
patible with the work place conditions.
y
Use caution when positioning the material lift over
rough surfaces, on slopes and when turning.
y
Do not engage in any form of horseplay or permit
riders on the material lift.
Warning
The potential for an accident increases when operat-
ing a material lift that is damaged or malfunctioning.
Death or serious injury could result from such acci-
dents. Do not operate the material lift if it is damaged
or malfunctioning.
Do not operate the material lift if it is damaged or not
functioning properly. Qualified maintenance personnel
must correct the problem before putting the aerial platform
back into service.
Before Operation
Follow these safety rules before operating the material lift:
ALWAYS
position the material lift on a firm, level surface.
ALWAYS
inspect the work area for potential hazards such
as overhead obstructions, unstable or slippery surfaces,
drop-offs, holes, debris or moving vehicles.
ALWAYS inspect the equipment before operating the
material lift. Check for damaged or worn parts.
NEVER
operate a material lift if any damage to the equipment is
observed or suspected.
ALWAYS
tag a damaged material
lift and remove it from service until repairs are completed
according to manufacturer’s specifications.
ALWAYS
inspect the winch and cable before operating
the material lift. Check for wear, frays, kinks and damage
to the cable. Verify that the cable is wrapped around
the winch drum at least four times when the carriage is
lowered.
NEVER
operate a material lift if any damage to
the winch or cable is observed or suspected.
NEVER repair the material lift in any way other than
according to manufacturer’s specifications.
ALWAYS verify that all decals are legible and correctly at-
tached to the material lift before operating the equipment.
NEVER deface, modify or obscure any decals or markings
on the material lift.
NEVER modify the material lift in any way that would
affect its original design or operation.
NEVER operate the material lift in any way for which it
is not intended.
During Operation
Follow these safety rules while operating the material lift:
NEVER operate the material lift near power lines. AL-
WAYS ensure that no part of the material lift can acci-
dentally reach into an unsafe area.
Danger
The material lift is not electrically insulated. Death or
serious injury will result from contact with, or inade-
quate clearance from, an energized conductor. Do not
go closer than the minimum safe approach distance
as defined by ANSI.
Allow for mast movement or electrical line sway due to
environmental conditions.
ALWAYS
assume every power line is live.
ALWAYS
keep away from a material lift that is exposed
to energized power lines. If the material lift contacts ener-
gized power lines,
NEVER
touch or operate the machine
until power lines are shut off.