Snorkel ML10I, Руководство оператора

Страница: 16 / 28

Chapter 4 – Prestart Inspection
12 ML5I • ML10I • ML15I • ML20I • ML25I – 7030242
9. Insert the fork retainer pin through the load lifting
attachment and the carriage.
10. Engage the locking toggle on the fork retainer pin.
11. Rotate the carriage hold-down bar up and away from
the carriage.
Material lifts equipped with adjustable forks
1. Pull up on the snap pins.
2. Adjust the forks to the desired width.
3. Verify that the snap pins are properly inserted.
To install fork extensions
1. Slide the extension tube onto the fork.
2. Adjust the extension tubes to the desired position.
3. Insert the retaining pins through the extension tube
and the fork.
Material lifts equipped with a load platform
1. Place the load platform on the forks.
Function Test
After the material lift is set up, perform the following test
to verify that the equipment is not malfunctioning.
1. Shift the winch to the slow speed.
2. Firmly grasp both winch handles.
3. Rotate the winch handles toward the mast to raise
the carriage to its full height.
The winch should operate smoothly, without hes-
itation or binding, and the motion should raise the
carriage to the top of the first mast section followed
in order by each consecutive mast section.
4. Rotate the winch handles away from the mast to
completely lower the carriage.
5. Rotate the winch handles one quarter-turn toward
the mast, as if raising the carriage, to set the brake
The winch should operate smoothly, without hesitation
or binding.
Work Area Inspection
NEVER set up the material lift where any of the following
hazards exist:
y
Drop-offs
y
Holes
y
Debris
y
Uneven or unstable surfaces
y
Surfaces that will not support the forces imposed by
the material lift, its operation and its load.
y
Slippery surfaces
y
Slopes
y
Overhead obstructions
y
Power lines or other electrical conductors
y
High winds or inclement weather
y
Moving vehicles
ALWAYS position the material lift on a firm, level surface.
Placards and Decals
To inspect the placards and decals:
1. Inspect all safety and operational placards and
decals. Make certain they are in place, in good con-
dition, and are legible.
2. Clean the placards and decals with soap and water,
and a soft cloth if the words or pictures cannot be seen.
Caution
Solvents may contain hazardous ingredients. Follow
the manufacturer’s label for proper use and dispos -
al. Wear protective gloves and splash-proof safety
glasses when using solvents.
3. Remove wet paint overspray with a natural biode-
gradable solvent and a soft cloth.
4. Replace any missing, damaged, or illegible placards
or decals before operating the aerial platform.
Placard and decal kits are available from Snorkel.