Snell ES-103, Руководство по эксплуатации и перечень запасных частей

Страница: 9 / 44

AS-23-33 2019.06
9
Troubleshooting
1.
The gripper is locked in the raised position
Remedy:
1. Turn the motor switch OFF, then turn it on again
2. If this does not work, adjust the switch level below the slide for LS1, so that activation and
disactivation of LS1 is correct.
2.
The roller is wedged against the guide
Remedy:
Remove shaft holder, loosen and set screw for fixing the guide (11), and then refix the guide with a
clearance of 0.1- 0.2 mm
3. Bad sealing
Remedy:
In most cases of poor heat-sealing, the heater temperature is either too low or too high. Make the ap-
propriate adjustment.
4. Low heater temperature
The strap shows no trace of having been melted and is easily pealed off. Lower the heater tempera-
ture by adjusting the control knob on the heater transformer.
5. High heater temperature
The strap is deformed, curled or poorly aligned and not sealed.