IQSDA41/42
Operation Using the RollCall Control Panel
Issue 1 Rev 1
Page 18
© 2017 SAM
5.3 Input Output Page
The
Input Output
page enables inputs and outputs to be configured, and determines how the
module behaves in the event of an input error.
5.3.1 Configuration
Use the radio buttons to select the input/output configuration. The options available are
dependant on the particular module hardware configuration in use; the other controls on the
page will also vary depending on the option selected.
5.3.2 Inputs
These controls are used to configure inputs; select the input rate(s) to be re-clocked.
Re-clocking can be disabled on an output-by-output basis if required (see section 5.3.3), or
globally by enabling
Reclocker Bypass
.
•
Rate Select:
Enable check boxes to specify the rate(s) to which an input will be
re-clocked. If check boxes are disabled, input signals at those rates will be muted.
•
Reclocker Bypass:
Enable to prevent re-clocking on all input signals.
5.3.3 Outputs
Each output can be muted individually; select
Mute
to manually apply mute as required.
.
Note:
If an incoming signal contains errors or is otherwise invalid, it will be automatically muted.
