Snapper 6-3172, Инструкции по безопасности, установка и руководство оператора

Страница: 6 / 16

6
SECTION 1 – ASSEMBLY INSTRUCTIONS
STEP 5
DECK ADAPTER INSTALLATION
E.
Secure the front of the adapter to the gage wheel
mounting bracket with the mounting strap. Secure
side of adapter with mounting strap hooked into deck
flange. See Figure 1.7.
FIGURE 1.7
FIGURE 1.7
STEP 6
DUST SKIRT & FRAME ASSEMBLY INSTALLATION
A.
Attach dust skirt to catcher frame with the heat
patch located towards the muffler side of the
machine. Locate the two oblong holes at the top
front of the skirt. Carefully remove the material
filling the holes. A knife or scissors may be required
B. Lay dust skirt flat on floor with heat patch to the
right and oblong holes away from you. Position
frame over skirt and align frame bumper mounting
brackets with oblong holes in skirt. Pull skirt up the
brackets, wrap edge of skirt around outside of
frame tube and position the 5 eyelet holes down
over the frame studs. See Figure 1.8.
FIGURE 1.8
C. Position catcher frame over rear bumper and
secure in place with (2) 5/16” diameter clevis pins
and (2) hairpins. NOTE: Skirt must be behind
bumper, away from engine. See Figure 1.9.
FIGURE 1.9
D. Attach catcher latch to frame assembly using (1)
#10-32 x 1 11/16” screw and (1) #10-32 Nyloc lock
nut. Tighten nut so that the latch is snug but still
able to rotate. See Figure 1.10.
FIGURE 1.10
(Continued on Next Page)
DUST
SKIIRT
(5) FRAME STUDS
2
1
3
4
5
BUMPER
MOUNTING
BRACKETS
HEAT
PATCH
5/16”
CLEVIS PINS
& HAIRPINS
CATCHER
LATCH
(1) #10-32 x 1-11/16”
SCREW & NYLOC
LOCK NUT
ADAPTER
ADAPTER
MOUNTING
STRAP
ATTACH HOOK TO
DECK FLANGE
ATTACH
HOOK
TO GAGE WHEEL
MOUNTING BRACKET