Snapper 6-3172, Инструкции по безопасности, установка и руководство оператора

Страница: 5 / 16

5
SECTION 1 – ASSEMBLY INSTRUCTIONS
WARNING
Front weight plates must be installed before
operating machine with grass catcher.
STEP 3
FRONT WEIGHT PLATE INSTALLATION
A.
Remove (4) knobs attaching floor pan to front
frame. Remove floor pan.
B. Attach (4) weight plates to front frame using (1) 3/8-
16 x 2” hex bolt, (2) 3/8” flat washers, (1) 3/8” split
lock washer and (1) 3/8-16 hex nut. Place four
weight plates on front bumper and align holes.
Insert bolt with flat washer from top. Secure weights
in place with flat washer, split lock washer and hex
nut. Tighten securely. See Figure 1.4.
C. Do not install the floor pan at this time
FIGURE 1.4
WARNING
DO NOT operate machine without entire grass
catcher or guards in place.
STEP 4
MOUNTING STRAP INSTALLATION
A.
Install mounting straps to the grass tube and deck
adapter using hardware supplied in kit. See Page
12 & 13 for parts illustration.
STEP 5
DECK ADAPTER INSTALLATION
A.
Remove the carriage bolt and lock nut, which
secure the pivot rod to the deck. See Figure 1.5
B. Slowly lift the loose end of the pivot rod to release
the tension on the deflector spring.
C. Remove the deflector, pivot rod, spring and mounting
rod from the deck. (NOTE: Save all parts for future
use when not bagging grass).
D. Install screw, washer and “T” nut from kit. Tighten
securely. Mount adapter to side of deck. See Figure
1.6.
WARNING
The lower end of the spring is held under tension by
the spring slot and can cause injury to the hand or
fingers when it is released.
FIGURE 1.5
FIGURE 1.6
(Continued On Next Page)
3/8-16 X 2” HEX BOLT
& FLAT WASHER
(4) WEIGHT
PLATES
DEFLECTOR
SPRING
SPRING
SLOT
REMOVE
CARRIAGE
BOLT
38”
DECK
REMOVE
NUT
WASHER
P.N. 9-0188