34
5.3.2.3-1
5.3.2.3-2
5.3.2.3-3(1)
5.3.2.3-3(2)
5.3.2.4-1
5.3.2.4-2
Operation
5.3.2.3 Alu2 and Alu3 (HWM) mode
Select this mode for more exact balancing, weight
positioning behind spokes or special rims (PAX, TRX,
CTS, etc.).
When selected, the display shows:
HWM1: Refer to Figure 5.3.2.3-1.
Two stick-on weights.
HWM2: Refer to Figure 5.3.2.3-2.
Left plane: clip-on weight
Right plane: stick-on weight.
Note
:
The relevant HWM indicator is lit.
Figure 5.3.2.3-3 (1) and (2) shows the rim reference
points.
The distance between the left plane and right plane
offset points must be 77 mm (3”) minimum.
Note
: To balance a PAX wheel (HWM1 only):
•
Select mm mode (Chapter
5.2.4.2
).
•
The rim diameter can only be changed to the
predefi ned values. Enter dimensions.
•
After entering the dimensions, spin the wheel.
Always apply the
stick-on weights
at the positions
indicated. Check the correct weight application
distance when the display shows the value “0“ and
the machine beeps.
•
Apply the weight in the left plane.
Note
:
If the weight is to be split and put exactly
behind two spokes, select SWM now.
Refer to Chapter 5.12.
•
Apply the weight in the right plane.
•
Perform a check spin.
5.3.2.4 Static balancing
Only static imbalance is measured and corrected.
When selected, the display is as shown in Figure 5.3.2.4-
1.
Figure 5.3.2.4-2 shows the recommended rim
reference point.
•
Establish the following dimensions:
-
Rim diameter of the reference point.
-
Width. If the rim width is
≤
3”, enter 3”.
-
Offset of the reference point.
•
After entering the dimensions, spin the wheel.
•
Apply the
stick-on
or
clip-on
weight at the 12
o’clock position.
•
Perform a check spin when done.
Содержание Sun SWB 100
Страница 90: ...90 Blank Page ...
