Snap-On EEWB308B, Руководство по эксплуатации

Страница: 10 / 20

Page 8
2.3 FLANGE ADAPTER INSTALLATION
Mount the flange adapter plate onto the shaft back plate
using supplied nuts and washers. Do not over tighten.
Refer to Figure 7.
2.4 ARBOR INSTALLATION
IMPORTANT!
CHECK THAT THE SURFACES ARE PERFECTLY
CLEAN AND NOT DAMAGED. AN INCORRECT
MOUNTING MAY RESULT IN SIGNIFICANT IMBAL-
ANCE.
Mount the threaded shaft onto the arbor of the balancer.
Tighten firmly, but do not exceed 70 inch lbs. See Figure
7.
Figure 7
2.5 DISTANCE GAUGE EXTENSION
Mount the Distance gauge extension to the Distance
Gauge arm. See Item 9 on page six for photo of the
gauge arm extension.
2.5 ELECTRIC INSTALLATION
ANY ELECTRICAL WIRING MUST BE PER-
FORMED BY LICENSED PERSONNEL.
ALL SERVICE MUST BE PERFORMED BY AN AU-
THORIZED SERVICE TECHNICIAN.
Check on the plate of the machine that the electrical
specifications of the power source are the same as the
machine. The machine uses 115VAC, 50-60Hz, 1Ph,
2.0 Ampere. Plug the AC power adapter into teh recep-
tacle on the rear of the machine. See Figure 8
NOTE:
Any electrical outlet installation must be verified by a
licensed electrician before connecting the balancer.
Check that the outlet has an automatic ground fault cir-
cuit breaker with a differential circuit set at 30 mA.
NOTE:
This machine performs a self-test routine on start-
up. There will be a delay of several seconds be-
fore the display is activated.
Figure 8
Rear