PRESSURE WASHER TERMINOLOGY
Following are common terms associated with the use of pressure washers:
PSI:
Pounds per square inch – common unit measure used for water pressure, air
pressure, hydraulic pressure and pounds of force.
GPM:
Gallons per minute (liters per minute [metric]) – common unit measure used
for flow rate of water.
Bypass Mode:
In bypass mode, high pressure pump recirculates water because
spray gun trigger is not squeezed.
Thermal Relief Valve:
When in Bypass Mode, this valve releases a jet of of water to
prevent water temperatures from reaching harmful levels that damage the pump. Once the
water has cooled, the thermal relief valve will reset itself. Do not allow pump to run
without spraying (in Bypass Mode) for more than 5 minutes.
ASSEMBLY / ATTACHMENTS
This pressure washer requires some assembly (tools provided) and will be ready for
use after servicing with manufacturer approved oil and fuel. If you have any prob-
lems with the assembly of your pressure washer, please call the pressure washer
helpline at
1-888-278-8092
. If calling for assistance, please have the model, revision,
and serial number from the data tag available.
PRESSURE WASHER
Unit is heavy.
Do not attempt to lift and remove
the pressure washer unit from the carton.
1. Using a box cutter, open carton completely by cutting the four corners allowing
the sides to lay flat. Leave pressure washer on the carton.
2. Remove all items except the pressure washer from the box and inspect for com-
pleteness (See Functional Description).
3. Carefully tip the pressure washer forward and place on its front side and
proceed to assemble the unit using the provided tools.
4. Insert the axles through the holes in the bottom frame from inside as
shown. Assemble the wheels to the axles from outside (using the cotter pins). To
secure the Wheels to the axles, insert the Cotter Pins inside the small holes in
the axles and bend back the end of the Cotter Pins using a pair of pliers (not
provided).
5. Assemble the Legs to the bottom frame tubing (using the washers, nuts and
bolts) as shown. Tighten all mounting hardware.
6. After completion of wheel/leg assembly, carefully place the pressure washer on
its wheels and legs.
15
Содержание 870599
Страница 44: ...42 ...
