4
–
Do not use water spray and steam to clean the appliance.
The appliance should be transported in the vertical position; do not
tilt any more than 30°. The manufacturer will not be responsible for any
damage of the appliance that results from non-compliance with the
instructions for transportation.
The manufacturer guarantees reliable operation of the refrigerator when
the relative air humidity not greater than 70 per cent and the ambient
temperature is:
+16 TO +32 DEGREES CELSIUS (Climate class N);
+16 TO +38 DEGREES CELSIUS (Climate class ST);
+16 TO +43 DEGREES CELSIUS (Climate class T).
INSTALLATION AND OPERATING CONDITIONS
Positioning:
•
This appliance can be installed in a dry, well ventilated indoor where the ambient
temperature corresponds to the climate class indicated on the rating plate of the
appliance.
Do not install this appliance in areas that are too humid or too colds, such as the
construction appendices, garages or wine cellars. Place the appliance away
from heat sources such as kitchen stove/oven, radiators, or
direct sunlight. The appliance must not touch any pipes for
heating, gas or water supply, or any other electrical
devices.
Minimum distances from the heat sources:
- from the electric gas and other ovens - 30 mm,
- from oil or coal fired ovens - 300 mm,
- from built-in ovens - 50 mm
If there is no possibility of ensuring the above-
mentioned distances, provide an appropriate
insulation board
•
Do not cover the ventilation holes at the top of
the appliances – it must be a good air
circulation around the appliance. There
should be a gap of at least 10 cm between the
top
of
the
appliance body and any furniture that may be
above it. If this
requirement is not followed, the appliance
consumes more
electrical energy and its compressor may
overheat
(see
fig.).
•
The appliance must stand on a level surface
and must not touch the wall. If necessary,
regulate the height of the appliance by adjusting
F 10SM F 22SM, F 27SM
