11
6. Remove the screw caps a and the blinds b. Unscrew the 9 fixing screws of the handle
and screw the handle on the opposite side of the door. Press the blinds into the remaining
holes in the door and place the covers on the screws.
7. Rotate the bracket 6 together with the washers on the shaft and the plastic gasket at
an angle of 180 °. Unscrew the shaft together with the washers and screw in on the
opposite side of the bracket. After inserting the axis 6 of the bracket into the door of the
refrigerator compartment, screw it on the opposite side of the refrigerator in the lower
holes. Cover c with the bracket and the remaining empty cavity.
8. Insert the cover 4 into the guides on the opposite side of the bottom cover 3. Replace
the bottom cover 3 in its original position.
Wait for about 30 minutes before it is connected to the mains. If the unit has been tilted
to more than 30°, wait for about 4 hours before re-connecting it to the mains
.
F 10SM:
WARNING! Turn off the freezer and pull the plug out of the electricity supply outlet.
1.
Remove support 1 and undo screws 2.
2.
Undo the two screws 3 that hold the pull-out shelf.
3.
Remove pull-out shelf 4.
4.
Take off bracket 5 together with the washers that are on the axle.
5.
Unscrew the axle from bracket 5 together with its washers and screw it into the second
aperture of bracket 5.
6.
Remove compartment door.
7.
Remove plug 7 from freezer door and press it in on the opposite side.
8.
Take off bottom bracket 8 together with the washers that are on the axle. Unscrew the
axle by turning it counter-clockwise. Turn bracket 6 around a full 180° and screw the
axle back in. Fix the bracket in place on the opposite side.
9.
Mount freezer door on the axle of bracket 8.
10.
Fix bracket 5 in place together with the washers that are on the axle.
11.
Put the pull-out shelf back in place and replace screws 2 and 3. Place support 1 in the
groove at the top back part of the freezer.
12.
Remove bolt caps a and plugs b. Unscrew the bolts holding the handles in place. Move
the handles to the other side. Screw on. Press plugs into the remaining apertures in
the door and cover bolts with caps a.
Wait for about 30 minutes before it is connected to the mains. If the unit has been tilted
to more than 30°, wait for about 4 hours before re-connecting it to the mains
.
