Assembly
Step 29: Install Warming Rack
Locate:
Warming Rack, and (2) M6x30 bolts
Procedure:
The Warming Rack is attached
to the Gas Grill. Screw (1) M6x30 bolt
through the Lid from the outside as shown in
Fig. 29A and Fig 29B and position the
Warming Rack so that the bolt is going
through the wire loop. Then align the wire
loop on the opposite end of the Warming
Rack with the opposite Lid hole and insert
the other M6x30 bolt. Insert the wire legs
into the holes of the Cabinet as shown in
Fig. 29C
Step 30: Attach the LP Cylinder Wire
Retainer
Locate
: Attach the LP Cylinder Wire
Retainer
Procedure
: refer to Fig. 30 – Squeeze
the Wire Retainer ends inward and
then allow them to snap back open in-
side the (2) retaining brackets on the
Bottom Shelf.
Step 29
Step 30
Fig. 29 A
Fig. 29 B
Fig. 29 C
Fig. 30
27
