Assembly
Step 25: Installing the Igniter Battery
Locate
: The AA battery can be found on
the Hardware Blister Card
Procedure:
Refer to Fig. 25 – unscrew the
black cap from the Electronic Igniter. In-
sert the AA battery with the + end facing
out. Screw the black cap back onto the
Igniter. When you press the soft black
button on the cap, you should see small
sparks jumping from the electrodes onto
all the Burner Tubes and the Sear Burner.
The Igniter will light ALL the burners when
you open the gas control valves and
press it.
Note
:
Make sure when your screw the black
cap onto the electronic ignitor, you do
not cross thread the cap.
Step 25
Fig. 25
Step 26: Match Holder and Chain
Locate
: Match Holder and Chain and (1)
M6x15 bolt
Procedure
:
Attach Match Holder and Chain to the top rear
hole in the left rear leg by inserting the (1)
M6x15 bolt through the loop of the chain and
securely tightening, see Fig. 26.
Step 26
Fig. 26
25
