Step 24:Sear Burner Assembly
Locate:
Sear Burner Housing and Lid, Sear
Burner, Gas Valve Control Knob, (11) M6x15
bolts and (2) ST4.0x10 screws, (2) Handle
Stand-offs, (1) short Handle Tube.
Procedure
: Refer to Fig.24A - Open the Sear
Burner Lid and place (2) M6x15 bolts through
the Lid holes on one side of the Lid. Fit a Han-
dle Stand-off over the bolts and attach the
Stand-off to the Lid. Fit the Short Handle Tube
into both Stand-offs and then repeat the pro-
cedure of inserting the screws through the Lid
and into the other Stand-off. Tighten all (4)
bolts securely.
Refer to Fig. 24B – Insert the (4) bolts ( 2 in
each Leg ) and leave them about ¼” out. Now
“hang” the Sear Burner Housing onto these
(4) bolts and push down to seat it, then tighten
the bolts securely. Note: (2) bolts need to be
tightened from the underside of the Housing.
Refer to Fig. 24C – and add (3) additional
M6x15 bolts from INSIDE the Cabinet to se-
cure the Sear Burner.
Refer to Fig. 24D – Pick up the HVR and hold
the Gas Valve in your hand and UNSCREW
the (2) M4x5 bolts.
Refer to Fig. 24E – Position the valve in place
between the front panel of the Sear Burner
Housing and the inner wall. Align the threaded
holes in the valve with the holes in the Sear
Burner Housing and attach the valve using the
(2) M4x5 bolts that were removed earlier.
Assembly
Step 24
Fig. 24 A
Fig. 24 C
Fig. 24 D
Fig. 24 E
Fig. 24 B
23
