IR lamp control module - HELCON 11XX series -
Installation, use and maintenance manual - EN
Ver. 1.02
27
Address 0 must never be used.
Since the address is acquired by the module only when the auxiliary voltage is switched on, the setting must
be made before powering it, otherwise the variation is ignored until the next power up of the module.
5.5.2 Automatic addressing
At the date this manual is written this mode can not be used, but a brief description of its operation follows.
In this mode the module address is set automatically according to the order of connection of the device in the
bus. In fact, taking advantage of the cascade connection of the bus, the FLxIO master device assigns the ad-
dresses sequentially; the first device connected to the master will thus take address 1, the second device con-
nected in cascade to the first will take address 2 and so on.
Check the correctness of the address before powering the devices, or the system may have
unpredictable behavior; danger of damage to people and/or things.
Decimal
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
Hexadecimal
0
1
2
3
4
5
6
7
8
9
A
B
C
D
E
F
