IR lamp control module - HELCON 11XX series -
Installation, use and maintenance manual - EN
Ver. 1.02
17
5.3.1 Power supply - J1
This is the mains supply (2 PH), using the J1 connector (2-pole 1000V 100A male; manufacturer: Ilme, code
CX 02 GM). The image and the pinout of the connector are shown below:
The following paragraphs describe in detail how the connections are to be made.
For safety reasons, the device must always operate with the PE connection inserted; danger
of electrolocution! The cross-section of the protective conductor (PE) must be not less than
that of the phase conductors.
L1
L2
PE
400 VAC power supply
Marker
Signal
L1
400 VAC network - phase 1
L2
400 VAC network - phase 2
PE
Earth protection
