-9-
1.7 Removal of side cover
Both sides or one side of the side covers can be removed from the desktop duster box. By removing the
side cover(s), it is possible to mount the desktop duster box on the conveyor line and place workpieces
from the side of the body. However, the amount of dust scattered outside will be larger than usual due to an
increase in the opening area.
(1) Remove the holding screws (2pcs.) on the side of the desktop duster box.
(2) Slide the side covers while lifting the top cover assembly as shown in the figure below.
The piping and wiring of the top cover assembly and body are connected, so do not lift the top cover
more than required.
(3) Return the top cover assembly to the original position while placing the position of the tube to the slot in
the body. Tighten the holding screws with a 1.50+/-0.15Nm of the tightening torque while holding the top
cover assembly horizontal.
Tube
Tube
Slot
Top cover assembly
Slot
Left side
Holding screw
Right side
Holding screw
Holding screw
Left side
Right side
Holding screw
Side cover
Top cover assembly
