SMC Networks SMCCO10-Z, Руководство пользователя

Страница: 10 / 17

SMCCO10-Z CO Alarm User Guide
Copyright
©
2013 SMC Networks
Page 10
All Rights Reserved
I/M SMCC010-Z rev. 1.0
1/23/2013
9/3/10
B.
Perform steps A through D in Step 6,
“Adding to the Touchscreen” on
page 3.
C.
At the Technician Settings menu,
select
Sensors & Zones > Delete a
Sensor/Zone . The Premise
Passphrase keyboard appears.
D.
Enter the Premise Passphrase and
click
Done . The currently installed
sensors/security zones appear.
E.
Tap the zone you want to delete
and follow the instructions on the
Touchscreen to delete the
SMCCO10-Z and security zone from
the current system.
11
Troubleshooting
SMCCO10-Z does not power up
properly or reports low battery
 Be sure the batteries are fully
seated within the battery
compartment and the polarity is
correct.
 Check the battery voltage (1.5 VDC
nominal per battery).
Touchscreen does not respond

Use a wireless RF sniffer to confirm
that the SMCCO10-Z is sending
messages for activation.
 Be sure the SMCCO10-Z is enrolled
into the Touchscreen properly.
 Be sure you are using a compatible
Touchscreen (see “Specifications”
on page 11).
Tamper condition does not restore
 Be sure the SMCCO10-Z is installed
on the mounting plate properly and
the mounting plate has a magnet.
 Be sure there are no trouble
indications at the CO alarm.
 Be sure you are using a compatible
Touchscreen (see “Specifications”
on page 11).
If a tamper alarm occurs
 Be sure you are using a compatible
Touchscreen (see “Specifications”
on page 11).

Be sure the Touchscreen is in sensor
test mode during sensor testing.
Alarm/open condition does not restore
 Be sure the smoke or heat has
cleared the SMCCO10-Z.

Be sure you are using a compatible
Touchscreen (see “Specifications”
on page 11).