-17-
No.PF
※※
-OMY0005
Terminology
Definition
O
Operating fluid temperature
Range of fluid temperature that can be measured by the product.
Operating humidity range
Humidity range in which the product can operate.
Operation mode
Hysteresis mode, window comparator mode, Error output or Output OFF can
be selected.
Operating temperature range
Ambient temperature range in which the product can operate.
Output light
A light that turns on when the switch output is ON.
P
Peak value display (mode)
Shows the maximum from when the power was supplied to the current time.
Pressure characteristics
Indicates the change in the display value when the fluid pressure changes.
Proof pressure
Pressure limit that if exceeded will result in mechanical and/or electrical
damage to the product.
R
R.D.
Current read value
For example, when the display value is 1.000 [MPa],
5%R.D. is
5% of
1.000 [MPa], which becomes
0.05 [MPa]. When the display value is
0.800 [MPa],
5%R.D. is
5% of 0.800 [MPa], which becomes
0.04 [MPa].
Rated flow range
The flow range within which the product will meet all published specifications.
Values outside of this range can be set as long as they are within the set flow
range, but the specifications cannot be guaranteed.
Rated pressure range
The pressure range within which the product will meet all published
specifications.
Values outside of this range can be set as long as they are within the set
pressure range, but the specifications cannot be guaranteed.
Rated temperature range
The temperature range within which the product will meet all published
specifications.
Values outside of this range can be set as long as they are within the set
temperature range, but the specifications cannot be guaranteed.
Repeatability
Reproducibility of the display value, when the measured quantity is repeatedly
increased and decreased.
Residual voltage
The difference between the ideal ON voltage and the actual voltage when the
switch output is on. Varies with load current. Ideally should be 0 V.
Reversed output
One of the switch output types. In hysteresis mode the switch output is turned
ON when measured value less than or equal to the switch output set value is
detected. In window comparator mode, the switch output is turned ON when
measured value is outside the switch output set values (n1L to n1H) is
detected.
(Refer to the "Switch output modes" on page
.)
