SMAY iSWAY-FC, Руководство по эксплуатации и обслуживанию

Страница: 66 / 168

Operation and Maintenance Manual (DTR) iSWAY
®
Set of products
Version 1.8 of 2.2021 66
The connection of the iSWAY devices to the TSS-6 is shown below (number 6 means that the
panel is intended for control and monitoring of 6 iSWAY devices). They can be either iSWAY-FC,
iSWAY-WFC, iSWAY-RFC. The connection of iSWAY devices to TSS-2 to TSS-5 panels is similar to
the following only instead of 6 devices, it will be 2 and 5 iSWAY devices respectively.
Fig. 13.8. Block diagram for the connection of the TSS-6 Control and Display Panel with the iSWAY device
It is possible to make TSS-(1,2,3)-24V devices, using 24VDC guaranteed power supply. These
devices can then be powered from the iSWAY-
FC® , iSWAY- WFC®, iSWAY - RFC®. Such versions
are shown in Figures 13.9, 13.10 and 13.11.
WIRING
Designation
on the
diagram
Automation elements connections Cable type
A1 Guaranteed power supply cable
3x400V for iSWAY-FC/-WFC/-RFC
NHXH FE180/PH90 5x cross section
A2 Ventilator power supply
3x400V for iSWAY-FC/-WFC/-RFC
NHXCH FE180/PH90 4x cross section
B1 Guaranteed power supply 1x230VAC
MSPU, TS, TSS
NHXH FE180/PH90 3x1,5
C1 Control-power supply cable
24 VDC (double intake)
HDGs FE180/PH90 3x1,5
D2 Global FirsBus bus loop HTKSH FE180/PH90 ekw 2x2x0,8
E2 Cables:
ALARM SAP (NC)
Operation confirmation (NO)
Collective failure (NC)
HTKSH FE180/PH90 3x2x0,8
F1 Control/power supply cable
24 VDC (shut-off damper)
HTKSH FE180/PH90 2x2x1,0
G1 Power supply, alarm, failure, smoke
detector signal cable,
HTKSH FE180/PH90 3x2x0,8
Key:
- Control and Display Panel
- Static measurement of
pressure difference Ø5 impulse
cables
- Damper
- BLE24
– BELIMO actuator
Rescue crews access point
(monitoring room)
Double intake system Double intake system