Pressing ‘>’ (or if the key ‘2’ has been pressed in the previous menu) the updating session starts. You
will see the following page:
After a few seconds, an up-counter with the percentage of transmitted software will appear.
At the end of transmission (when the 100% is reached) Smarty will update the functional parameters
of the ECM. The following page will appear:
At the end of the updating session, the following page appears:
After a few seconds Smarty displays the following page:
Please, unplug Smarty from the diagnostic port and turn the Key of for 30 seconds.
Recovery of the ECM
If an interruption occurs during an Update or the Update operation is terminated before the normal end
for any reason the ECM will not be operational. You must recover the ECM using Smarty to resume
the update process.
Attention! The engine will not start before the ECM has been recovered properly!
( The Wait to Start Light will flash continuously )
DON’T PANIC!
Smarty Performance King
has developed a special boot loader software that is used during all the
ECM Updates. Unlike the OEM DRBIII tool, there’s no need to pull fuses or unplug the batteries! No
tools needed! At Smarty Performance King we’ve done our homework!
Just follow the directions on Smarty’s display.
Smarty will handle the situation for you in a few simple steps.
Unplug Smarty, then plug it in again. After a few seconds the usual main menu will appear.
Pressing the ‘1’ key, the second menu appears:
Press ‘1’ to select
ECM Update
.
Then the Options menu appears:
From the Options menu, press '1' to select Connect Truck.
Smarty will try to establish the communication with the ECM. The connection cannot be established
because the last updating session has been interrupted. Smarty knows that the last update has not been
performed correctly thus he’s able to recognise the not operational ECM condition.
Page 9 of 20