47
1. There are two options of Speed Source: "GPS" and "Vehicle", if selecting the “GPS”, the
speed of the vehicle can only be sent to the device when the device has the GPS module and
GPS signal. The vehicle can get the vehicle speed information by GPS.
2. If selecting the "Vehicle" to get the speed, you need to connect to the pulse sensor to
calculate the speed ratio (co-efficient = pulse / speed). The pulse sensor connects to the
device port SPEED-A and SPEED-B two lines and the speed ratio is measured according to
the set speed and pulse getting during vehicle traveling.
3. Speed unit KM / MPH can be switched. High-speed limit threshold means the maximum
speed of the speed limit. If you turn on the alarm, the alarm will be generated when the
speed exceeds the threshold. Alarm information can also be transmitted to center SVC
platform for recording.
4. When selecting Type to be Event, the record file is a normal record. When selecting the
type of alarm the record file type is alarm.
15.2 G-Sensor Settings
1. Enable on means this sensor turns on
2. Calibration is required before G-Sensor setting; calibration is to clear X / Y / Z parameters.
G-Sensor can be understood as a three-dimensional X / Y / Z axis, which respectively stands
for three groups of states: upper and lower, left and right, front and rear, uniform has no
effect, and the G-Sensor setting is mainly to set a threshold value, which needs to be
determined. Generally speaking vehicle’s instant acceleration is relatively large in case of
harsh braking, crash, acceleration and sharp turns whose intuitive reflection is threshold
beating and PC displays X \ Y \ Z three states by waveform when playing back. When an
alarm is generated, it also can be sent to center SVC MDVR-L platform to record alarm
information.
3. When selecting Type to be Event, the record file is a normal record. When selecting the
type of alarm the record file type is alarm.
