STEP 5:
•
Place barge flashings on roof at end of shed ensuring the
diagonal trimmed end is facing out. (See diagram on pg 5)
•
Rivet the Barge Flashings to the roof and the side wall, using
four rivets on top of barge and four into the side (
fig.3
).
ROOF ASSEMBLY CONT...
13
STEP 4:
•
Centralise the Roof at the other end (R/H end) with the
Ridge Beam.
•
Using 1 x 50mm Roofing Screw, fix roof sheet though the
pan, to the other end of Ridge Beam.
(d–fig.2).
•
Using 2 x 50mm Clouts fix sheet though rib to front & back
Top Plates. (
e–fig.2).
•
Ensure that the Ridge Beam is straight, screw roof sheets
to ridge beam beside each overlap, through the pan using
3 x 50mm Roofing screws.
•
Ensure the Front and Back Top Plates are straight. Screw
the roof sheets to the front & back Top Plates, through the
ribs, using 1 x Roofing Screw per rib. (
fig.1
).
STEP 6:
•
Rivet the Ridge Cap to the centre of the roof using 8 x
rivets as shown (
fig.2
).
STEP 7:
•
Place spouting in position and rivet to Barge Flashings at
each end and rivet to roof sheets (1 rivet per 1 sheet)
(fig.4).
= Clout
= Screw
fig.1
Pan
Rib
STEP 3:
•
Ensure shed is sitting level and square.
•
Beginning from the left hand end (looking from front) centralise the Roof sheets on the Ridge Beam.
•
Ensure that the Roof is tight against the Gable Wall Sheets. Screw 1 x 50mm Roofing screw through the 1st pan into
the Ridge Beam.
(a
-
fig.2).
•
At the back left hand corner, (from front) line up the ribs on the Roof Sheet with the ribs on the Wall Sheet then using
1 x 50mm Clout, predrill and nail Roof Sheet through the rib into the Top Plate.
(b–
fig.2.)
Repeat at the front
left hand
corner.
(c
-
fig.2).
fig.2
SIDE
WALL
FRONT WALL
BACK WALL
SIDE
WALL
TOP PLATE
BOTTOM PLATE
RIDGE BEAM
a
b
c
d
e
e
fig.3
X 4
X 4
Barge
Spouting
fig.4
IMPORTANT
Use 50mm Clouts only on ribs covered by flashings, shown in fig.2.
Predrill holes using a 3.5mm drill bit. Use Roofing Screws on all other
ribs and pans. Ensure screws are not overtightened as this can
damage the seals and cause the shed to leak.
Ensure screws are not
overtightened as this can damage the seals and cause the shed to
leak.
Содержание SM2020
Страница 1: ...ASSEMBLY INSTRUCTIONS SM2020 BASE SIZE 2 020m x 2 020m...
Страница 2: ......
